Been having fun playing with and learning my next workstation and have a new question. Powered down the unit to work on another project went to power back up after a couple of days and nothing happens. Anyway to test the keyboard to workstation or a general reset that I might have done. Can the pin outs on the cable be jumped to test the power supply. Knew i should have not started a different project. It is probably punishing me for leaving it. :D
The usual suspect is the battery on the logic board. The next uses this to power on.
tks will check also noticed the terminals are loose will re solder...
In both cases for me it was always the battery. new battery, and my systems powered right up.